DIY Epoxy Garage Floor coating.
Posted by LadulceLavie
There are a number of nationally and international professional floor coating companies but installing your own epoxy floor coating can be cost-effective and gratifying. A garage, play room or lapa area might not be the show off room of your house, installing attractive floor coating can help make it more appealing. This is similar to the staining the concrete that was done in my previous post but for more heavy duty use. It comes in various colours so you can choose according to the rooms specific décor and colour scheme.
Before you start, remove all furniture and items in the garage, clean the floor as best as possible and ensure the floor is level and roughly smooth by sanding if possible. Remove dust from cracks and corners to ensure that the Epoxy adheres to the floor as firm as possible, remove oil stains to the best of your ability then use either air-pressure or water-pressure spray the day before the application to ensure the floor is well dried, it is important to ensure that no moisture is still on the floor as this would not adhere otherwise. If the floor was previously sealed or painted remove with the relevant remover well in advance. To test for this presence, pour a small amount of water onto the floor if it seeps in there is no sealant and if it doesn’t, and instead forms beads of water on top, the floor still has some sealant.
Each of these preparation steps may be performed multiple times to ensure the whole surface is well prepared for priming. The process may take several days.
Mask of any areas that need to be protected with wide masking tape.
Please wear protective gear, it is essential to wear protective gloves, rubber boots, and safety glasses
Once the entire floor surface has been prepapred for coating, it is time to apply the primer. The primer is applied just like paint and allowed to settle for several hours before the epoxy goes on. This process is very simple and requires general painting tools, like a roller and a splash pan. Directions on the epoxy bottle should be followed, these may vary slightly between the different manufacturers but the generally go this way.
Apply the supplied EPOXYShield concrete etch and then rinse thoroughly and allow to dry completely, please note it will be easier to work in sections as opposed to applying to the entire floor.Allow the floor to dry completely before moving on to the next step, this may take several hours.
Depending on the manufacturer and the kind you have chosen, stir the contents of cans A and B and then pour A into B and mix well for approximately 3 to 5 minutes, then use a wide paintbrush to apply around the perimeter for a neat finish.
Pour epoxy into the paint tray. Insert the extension handle into the roller, dip in the paint tray and apply an event coating onto the surface working in small sections guarantees that the decorative paint chips will be scattered into the freshly coated surface.
Do not use the area for at least 16 hour and make sure it is well ventilated
Posted on March 23, 2012, in DIY, Great decorating ideas and tips, Interior decorating on a budget, Paint and tagged Coating, Cost-effectiveness analysis, diy, Epoxy, Floor, Garage, garage floor coating, garage floor treatment, Granite look floor paint, heavy duty floor paint, Masking tape, Paint, Primer, Primer (paint), Wine tasting descriptors. Bookmark the permalink. 9 Comments.